Filter Replacement - eta PURETEE Bedienungsanleitung

GB
II. DESCRIPTION OF THE APPLIANCE (Fig. 1,2)
A – Main unit (Fig. 2)
A1 – socket for the mains cable
A2 – the mains adapter
A3 – Air outlet
A4 – Air inlet
B – Control panel (Fig. 1)
B1 – Switch on/off button (
B2 – Fan speed button (
B3 – Speed level indicators
B4 – night light button (
III. INSTRUCTIONS FOR USE
Before first use, remove any packaging and protective material (including any protective film)
from the appliance and accessories.
CONTROLS
After switching the purifier into standby mode, plug the adaptor cable in electrical socket.
Acoustic signal will sound, and all indicator lights will turn on for a moment. Then the B1
button remains lit.
Switch on/off button B1 – Press the button to switch on the purifier in the basic filtration mode
Fan speed button B2 – You can switch the fan speed by repeated pressing of this button as
The B4 light button – when the appliance is on, the nightlight in the lower part of the purifier
SLEEP – Pressing B2 button to SLEEP activates silent mode recommended for night
operation. The cleaner will operate at the lowest speed level, and without any light
signals. The function may be disabled by pressing B1/B2 button.
UV function button B6 – Press this button to activate UV sterilization of the air flowing
Timer button B7 – Press this button to activate sleep function to switch off the device after 1,
2, 4 or 8 hours. After the set period expires, the purifier shall automatically
switch to standby mode. You may set the following values by pressing
the button repeatedly: 1 hour – 2 hours – 4 hours – 8 hours – function
switching off ...

FILTER REPLACEMENT

To replace HEPA filter A5, proceed according to Fig. 2. If the filter replacement indicator light
B5 is flashing, it indicates end of the filter's service life. B5 indicator light will flash after about
1500 hours of operation – then the filter must be replaced (unless it has been replaced earlier
due to impurities and higher dustiness level). To restart the signalisation function after the
filter replacement), press B4 and B6 buttons for 3 seconds. The signalisation function must
be restarted in the same manner also when you replace the filter before the signalisation light
is activated.
)
)
)
(speed Low). The set functions may be cancelled by repeated
pressing of these button, and the purifier may be switched back to
the standby mode.
follows: High – Mid – Low – SLEEP. The respective indicator light
B3 will indicate the respective speed setting.
is activated. Press the button again to turn off the light.
through. The function activity is indicated by blue backlight of UV
function ionization button. Press the button to switch off the function.
A5 – HEPA filter 3 in 1
A6 – Filter cover
A7 – UV lamp
A8 – UV lamp cover
B5 – Filter replacement indicator
B6 – UV disinfection function button
B7 – Timer button
22 / 47