Safety; Intended Use; General Safety Instructions; Test Mark - STIEBEL ELTRON MEKD Bedienung Und Installation

OpERATION

Safety

2. Safety
2.1

Intended use

The pressure-tested mono lever mixer tap is intended for op-
eration with a pressure-tested, sealed unvented instantaneous
water heater.
- MEKD for sinks
- MEBD for baths and showers
The product is designed for domestic use. It can be used safely
by untrained persons. The appliance can also be used in non-do-
mestic environments, e.g. in small businesses, as long as it is
used in the same way.
Any other use beyond that described shall be deemed to be out-
side the intended use. Observation of these instructions and of
instructions for any accessories used is also part of the intended
use of this appliance.
2.2

General safety instructions

WARNING Burns
During operation, the tap can reach temperatures in ex-
cess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
www.stiebel-eltron.com
2.3

Test mark

In line with State Building Regulations in Germany, a general test
certificate for the appliance has been applied for as verification of
its suitability regarding noise emissions.
3. Operation
1 Tap lever
2 Diverter valve: Spout and hand shower
f To obtain the required mix of hot and cold water, move the
tap lever forwards or backwards.
f To draw off water, move the tap lever to the right.
MEBD only
f While the water is running, pull the diverter valve upwards
slightly, to switch between spout and hand shower attach-
ment. The tap automatically reverts to the spout position
after draw-off has ended.
1
2
MEKD | MEBD | 17