DJI High-Bright Remote Monitor Handbuch Seite 7

2. When using the NP-F series batteries, remove the four M2×5 countersunk screws on the back
of the remote monitor, mount the NP-F battery adapter to the battery slot, and tighten the four
M2×6 socket cap screws. Insert the battery and push it to the end with the connector. Make
sure that the NP-F battery release button pops up, indicating the battery is firmly in place.
Press and hold the battery release button on the battery adapter and push the battery in the
opposite direction to remove it.
©
3 2023 DJI All Rights Reserved.
M2×5
M2×6