DJI High-Bright Remote Monitor Handbuch Seite 12

the remote monitor is near connected devices in an environment with weak interference, it is
recommended to set the bandwidth to 40M for best transmission quality. If the remote monitor
is far from connected devices in an environment with strong interference, it is recommended to
set the bandwidth to 20M for longer transmission distance and better anti-interference.
When using with the DJI Video Transmitter, if the video transmitter is linked to the remote monitor
in Control mode and Broadcast mode is enabled, users can select the prioritized mode.
Prioritized Mode: tap to select Control mode or Broadcast mode as the prioritized mode.
When Control mode is the prioritized mode, the transmission signal quality of the devices in
Control mode will have a priority. Users can select the channel mode. In this mode, devices in
Broadcast mode near the remote monitor may have a weak transmission signal.
When Broadcast mode is the prioritized mode, the transmission signal quality of the devices
in Broadcast mode will have a priority. Users can select the channel manually, while the
channel mode and downlink bandwidth cannot be selected.
7. Recording Parameters/LiDAR Focus
Recording parameters will be displayed when used with Ronin 4D including white balance,
ND, aperture, EI, and aperture angle or shutter speed (depending on Ronin 4D settings). Tap
to adjust the corresponding parameter.
The LiDAR focus distance will be displayed when used with the DJI LiDAR Range Finder (RS),
indicating the distance of the subject near the center of the image that is detected by the
range finder or the distance of the subject that is detected and locked.
8. Gyroscope Control
Tap to enter the settings menu to enable or disable Gyroscope Control. When enabled, set
the follow speed of the pan, tilt, and roll axes, and recenter the gimbal. Enter the advanced
settings to set the deadband and smoothness of the pan, tilt, and roll axes, calibrate the
compass, and reset to default.
When Gyroscope Control is enabled, hold this icon to pause control and the gimbal will keep
the current attitude. Release to resume control. Double tap the icon to recenter the gimbal.
• The Gyroscope Control icon will not appear here if Gyroscope Control is disabled in System
Menu.
• LiDAR waveform will not appear when Gyroscope Control is enabled.
9. Safety Zone
The safety zone can be used to assist in composition and also to reserve space for overlaid
information in advance such as TV station logos and program icons that need to be added
to the video. Users can enable or disable the safety zone and set the safety zone ratio in
General Settings. Note that the safety zone ratio is only a reference for monitoring and will not
affect the actual recording.
10. Frame Guide
Shows the pre-set frame guide. Users can select the frame guide ratio and transparency in
General Settings. Frame guide ratio customization is not supported at the moment. Note that
the frame guide ratio is only a reference for monitoring and will not affect the actual recording.
11. System Menu
Includes connection settings, general settings, local playback, about, and help. Refer to the
System Menu section for details.
12. Volume Level
Shows the current volume level. Green means the volume is safe, yellow means it is
©
8 2023 DJI All Rights Reserved.