DJI High-Bright Remote Monitor Handbuch Seite 19

When mounting the LiDAR range finder to other positions, such as the top of the camera lens,
adjust the distance to compensate for errors.
Tracking Sensitivity
Supports 5 levels. Level 1 offers the slowest change in focus. Level 5 offers the fastest change in
focus.
PiP
When enabled, the picture in picture window that displays the image from the visible light camera
on the LiDAR range finder will appear on the monitoring interface. Detection mark boxes will be
shown in PiP.
Drag the PiP window to move its position.
Set the magnification of PiP to 1x or 2x in the settings menu. When 2x is set, the PiP display will
zoom in with the center of the image as the reference point.
When the focus area is set to Wide mode, there will be white, gray, and yellow mark boxes
displayed in PiP.
White: a subject that is detected and is automatically focused on, which has a near distance from
the center of the image.
Gray: a subject that is detected and can be chosen to focus on, which has a far distance from
the center of the image.
Yellow: for a subject in the white mark box, use the dial or trigger on the right hand grip mounted
on the remote monitor to switch to the subject or to choose the subject, and the mark box will
turn yellow, indicating that the subject being focused on is locked. The focused subject will not
be switched even when the subject has a far distance from the center of the image.
©
15 2023 DJI All Rights Reserved.