Lidar Focus Assistant Settings; Lens Settings - DJI High-Bright Remote Monitor Handbuch

LiDAR Focus Assistant Settings

When connecting the DJI LiDAR Range Finder (RS) and the DJI RS Focus Motor (2022) to the DJI
Video Transmitter and remote monitor via the DJI LiDAR Range Finder (RS) to DJI Transmission
Cable Hub, tap or
AF MF

Lens Settings

Configure lens profile and calibration according to the lens in use.
Lens Profile
If using a digital lens, the lens profile can be read automatically. There is no need to add the lens
profile manually. Refer to the DJI LiDAR Ranger Finder (RS) section on the Specs page of the
official DJI RS 3 Pro website for supported lens models.
If using other lenses, input the lens profile manually. Up to three lens profiles can be added. Refer
to the corresponding file on the Downloads page of the official DJI Transmission website for
supported lens models.
Tap the Add button on the screen, input the focal length of the lens, and tap Calibrate. Follow the
onscreen instructions to complete lens configuration.
Lens Calibration
Lens calibration is required after switching lens profile or changing the mounting position of the
focus motor. Tap Calibrate and follow the onscreen instructions.
Flange Distance Adjustment
If the lens profile is added using the Ronin app, users can adjust the flange distance here to
eliminate the focusing error using different lens mounts, which makes focusing more accurate.
LiDAR Settings
Focus Mode
Select AF or MF.
Focus Area
Set the focus area to Wide or Flex Point. The mark box display in PiP (picture in picture) varies in
different focus area settings. Enable PiP in the settings menu to check the mark box.
In Wide mode, the LiDAR range finder automatically recognizes subjects such as people or cars
in the camera view and focuses on the subject nearest to the center. In Flex Point mode, the
range finder will focus on the subject inside the focus box displayed in PiP.
LiDAR Installation Distance
The installation distance is defined as the focus plane of the camera and the LiDAR range finder.
The default distance is 75 mm, which is the length of the LiDAR range finder mounting bracket
plus the length of the LiDAR range finder. Fine-tune the value to improve the auto focus accuracy.
©
14 2023 DJI All Rights Reserved.
on the bottom right of the monitoring interface to enter the settings menu.