Technical Data; Ordering Replacement Parts - EINHELL 34.003.50 Bedienungsanleitung

Anleitung EM 1501_SPK1

12. Technical data

Voltage: 230 V ~ 50 Hz
Power input:
Motor speed:
Cutting width:
Cutting height adjustment: 25-75 mm; 6 levels
Volume of catch bag:
LPA sound pressure level:
LWA sound power level:
Vibration at the handlebars:
14. Troubleshooting
Fault Possible causes
The motor fails to start a) The capacitor is defective
b) There is no electricity at the plug
c) The cable is defective
d) The combined switch/plug is
e) The connectors have become
f) The mower is standing in high
g) The mower housing is clogged
The motor performance drops a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
Cutting is irregular a) The blade is worn
b) Wrong cutting height
Important!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is overloaded and
switches on again automatically after a short cooling period.
19.12.2005 16:23 Uhr Seite 19

13. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
1500 watts
Type of machine
Article number of the machine
3400 rpm
Identification number of the machine
38 cm
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
40 liters
80 dB(A)
96 dB(A)
≤ 2.5 m/s
2
Remedies
a) The mower housing is
clogged Have repaired by
the Customer Service
Center
b) Check the cable and the
fuse
c) Check the cable
d) Have repaired by the
defective Customer Service Center
e) Have repaired by the
separated from the motor Customer Service Center
or the capacitor
f) Start in low grass or on an
grass area that has already
been mowed; change the
cutting height if necessary
g) Clean the housing so that
the blade moves freely
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
a) Replace or resharpen the
blade
b) Correct the cutting height
GB
19