Unit Activation; Leak Test Vacuum Time Change; Firmware Update; Wifi Configuration - Bosch ACS 553 Originalbetriebsanleitung

5.12

Unit activation

Failure to register and activate the station within
30 days of initial start-up causes the station to lock
and the impossibility to use it.
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Settings.
5. Select Unit Activation.
« The display shows
PERIOD REMAINED to activate the unit.
Activate now?
6. Select
to start the activation process.
« The display shows
code: xxxxxxxxxxx
Enter the code: xxxxxxxxxxxxxxxxxxxx
7. Open an Internet browser on a personal computer
and enter
https://register.servicesolutionsportal.com.
8. Enter your username and password, and log in to
access the website.
i
If you are accessing the site for the first time,
click the Registration button to create your own
username and password.
9. Enter the Personal Identification Number of the
station to receive an activation code.
10. Enter the activation code in the correct field on the
station.
i
Enter the code exactly as it was received. Use
uppercase if necessary.
11. Note the activation code and keep it in a safe place.
12. Select
to confirm.
« The station displays a message indicating that
the activation has been successful.
13. Select
to print or
"
Activation of the station has been successful.
5.13

Leak test vacuum time change

To change the leak test vacuum time, proceed as
follows:
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Settings.
5. Select Default Vaccum Leak Test Time.
6. Use the multi-touch interface on the numeric
keypad to change the value.
7. Select
to save.
Robert Bosch GmbH
XX DAYS OF THE TRIAL
to exit the function.
Initial settings | ACS 553 | 49 |
5.14

Firmware update

To upgrade a firmware, proceed as follows:
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Settings.
5. Select Firmware Update.
6. Use the Up or Down arrow buttons to select the
desired mode.
7. Select
to proceed.
8. Follow the instructions on the display.
i
To upgrade the firmware with USB key, insert the
key into the USB port of the station; while the
firmware upgrade via WiFi is necessary before
connecting the station to a WiFi network (see
chapter "WiFi Configuration").
5.15 Wifi configuration
Fig. 14: USB port location
1 USB port
1. Carefully insert the WiFi dongle (optional) into the
USB connector of the station.
2. Turn on the station and pair the dongle with the
Router on.
3. Call up the Main Menu.
4. Select
.
5. Select
.
6. Select Settings.
7. Select WiFi Configuration.
8. Select Search WiFi Networks and wait a few
seconds to display the available networks.
9. Select the network associated with the router with
the Up or Down arrow buttons and confirm with
.
10. Enter the router WiFi password, confirm with
and wait for the connection to be established.
i
Make use of Manual Connect function whenever
the WiFi network is not automatically detected
through the Search WiFi Networks function.
Manually enter the WiFi network name and
password paying attention to upper and lower
cases and then confirm with
en
1
.
|
1 689 989 627 2021-03-01