Protection Devices; Ped Directive 2014/68/Eu; Acs 553 Handling - Bosch ACS 553 Originalbetriebsanleitung

en | 40 | ACS 553 | Precautions
2.2

Protection devices

The station is equipped with the following protection
devices:
+
High pressure safety valves.
+
A high pressure switch that stops the compressor
when excessive pressure is detected.
WARNING: Tampering with these
protection devices can cause serious injury.
WARNING: Do not modify the high
pressure safety valve or the main
settings of the system. Using the machine
differently than as it was designed
compromises its functionality and invalid
the protections it is equipped with.
CAUTION: Always check the pressure
gauges readings to check that the
pressures are maintained within the limits
specified in the "Technical Data" section.
|
1 689 989 627 2021-03-01
2.3

PED directive 2014/68/EU

The machine includes parts subject to PED EU
directive 2014/68/EU, Pressure Equipment Directive.
PED directive regulates all the pressurized part
defining for them categories based on volume-
pressure ratio and based on fluid refrigerant type.
Those parts then have not to be anyhow modified nor
removed. Under the responsibility of the owner, the
machine and parts falling in the scope of PED shall be
checked either during commissioning and periodically
fulfilling local country regulations and norms.
Parts in the scope of PED are:
+
Tank.
+
Pressure relieve valve.
+
High pressure switch.
+
Recovery group.
+
Piping.
i
Call Bosch service center to get technical
specifications for each part listed.
2.4

ACS 553 handling

The ACS 553 must normally be moved on flat surfaces
with a maximum slope of 15° and on four wheels,
avoiding excessive shaking. When stopped the front
wheels brake must be engaged. On slightly irregular
surfaces, the ACS 553 can be moved, keeping it
slightly inclined and set on the ground on the two rear
wheels making sure to have a firm grip on the rear
handle.
CAUTION: Although the heavier components
of the ACS 553 are installed on the bottom
of the ACS 553 in order to lower the center
of gravity as much as possible, the risk of
overturning is not completely eliminated.
Robert Bosch GmbH