Use Of Oil Bottles; Turning On The Station; Language Selection; Unit Of Measurement Selection - Bosch ACS 553 Originalbetriebsanleitung

5.4

Use of oil bottles

i
Pay attention to the labels on both fresh oil bottle
(PAG or POE).
!
Only use oils that are approved by the vehicle
manufacturer. This prevents chemical incompatibility
with the station internal components. In the event of
problems and failures due to non-approved oils, the
warranty will be void.
1. Fill the fresh oil bottle with the correct compressor
oil (PAG or POE).
2. When prompted by the software, connect the
correct fresh oil bottle, PAG or POE, to the right
quick release coupling port.
3. Connect the oil drain bottle to the left quick
release coupling port.
2
Fig. 12: Position of bottles
1 Fresh oil bottle (PAG or POE)
2 Oil drain bottle
5.5

Turning on the station

1. Connect the power cable to the socket on the
station and to a outlet with the correct voltage,
equipped with grounding.
i
Do not use a power cable with inadequate
characteristics.
2. Place the station so that the plug and power switch
are at the operator's reach.
3. Make sure that the ventilation grille, on the rear of
the station, is not obstructed.
4. Lock the front wheels.
5. Press the mains power supply switch ON to switch
on the ACS 553.
"
The first time that the station is switched on, the
Initial Setup mode starts automatically. The software
displays the license agreement after the language
selection, this must be accepted by the user with
Robert Bosch GmbH
5.6
Choose the user interface language. The default
language is English.
1. Use the Up or Down arrow button to scroll through
the available languages, one line at a time.
2. Select
5.7
Set the units of measurement to be displayed. The
default ones are metric units.
1. Use the Up or Down arrow button to select
between the metric or British imperial system.
2. Select
displayed effective.
5.8
Use the arrow buttons to move the cursor. Use the
keypad to change the displayed information.
1. Use the Up or Down arrow buttons to change the
item displayed: day, month, year, or time.
2. Use the multi-touch interface on the numeric
keypad to change the information.
3. Select
5.9
1
The information loaded in Print header change will
appear on each print.
1. Enter the text using the arrow buttons and the
multi-touch interface on the numeric keypad:
+
the button
+
The Right or Left arrows button moves the
cursor to the right or left.
+
The Zero (0) key also acts as a space bar.
+
To navigate within the rows, use the Up and
Down arrow keys.
2. Select
.
Initial settings | ACS 553 | 47 |

Language selection

to set the selected language.

Unit of measurement selection

to make the unit of measurement

Setting the date and time

to save.

Print header change

acts as a backspace key.
to save.
1 689 989 627
en
|
2021-03-01