Installation - IKEA MÖJLIG Bedienungsanleitung

ENGLISH
Problem
lights up on the power
setting display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.

Installation

General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
Warning! The appliance must be
earthed!
Warning! Risk of injury from
electrical current.
• The electrical mains terminal is live.
Possible cause
The second phase of the
power supply is missing.
• Make electrical mains terminal free of
• Loose and inappropriate plug and
• Have the clamping connections correctly
• Use strain relief clamp on cable.
• Follow the connection diagram (it is
Important!
• You must observe the minimum distances
• If there is no oven beneath the hob insert
• Protect the cut surfaces of the worktop
Check if the hob is correctly
connected to the electrical
supply.
Remove the fuse, wait one
minute, and insert the fuse
again.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
voltage.
socket connections can make the
terminal overheat.
installed.
located on the underneath surface of the
casting of the hob).
to other appliances and furniture
cabinets or other units according to
Assembly Instruction.
a dividing panel at a minimum distance
of 20 mm from the bottom of the hob.
against moisture using a suitable sealant
included in the product in fitting bag. The
sealant seals the appliance to the work
top with no gap.
14
Remedy