Technical Data - EINHELL SB 401/1 Bedienungsanleitung

Anleitung SB 401-1-501-1 SKP 1
or the power cable.
Store the tools in a safe location
Store unused devices in a dry, locked location that is
out of the reach of children.
Avoid overloading the device
Operate the device only within the specified output
range. Do not use any low-powered machines for
heavy duty work. Do not use tools to perform work
for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and always
keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool, prior
to maintenance, and when changing the drill bit.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the object
you are working on. Never use the machine when
you are not concentrating or are distracted. Never
use the machine when you are under the influence of
alcohol or are taking medication.
Check the tool for damage
Before using the tool, safety devices and any slightly
damaged parts must be carefully checked to ensure
that they are in good working order. Visually examine
the tool's power cable on a regular basis. All parts
must be correctly assembled and meet all the
conditions required to ensure proper operation.
Unless otherwise specified in the operating
instructions, any damaged safety devices and parts
must be properly repaired or replaced by a
professionally recognized workshop. Never use tools
with defective On/Off switches.
Warning! Using any plug-in tools and accessories
other than those specified in these operating
instructions can lead to injury.
Maximum workpiece size
Workpieces (max. 20 x 20 cm) may only be
processed if they can be clamped securely on the
drill table or in the vise.
05.04.2004 11:47 Uhr
Now, please read and follow all steps and
procedures included in the operating
instructions.

5.0. Technical data

SB 401/1
Nominal input voltage 230V ~/ 50 Hz
Power rating
Operating mode S2 15 min.
Motor speed 1400 min-1
Output speed 580 – 2.650 min-1
Speed levels
Drill chuck mount
Scroll chuck Ø 1.5 - 13 mm
Max. shaft diameter
Throat 104 mm
Drill depth
Pillar diameter
Height 590 mm
Weight
LPA sound pressure level in idle mode
61,5 dB(A)
LWA sound power level in idle mode
74,5 dB(A)
SB 501/1
Nominal input voltage 230V ~/ 50 Hz
Power rating
Operating mode S2 15 min.
Motor speed 1400 min-1
Output speed 280 – 2.350 min-1
Speed levels
Drill chuck mount
Scroll chuck Ø 3-16 mm
Max. shaft diameter
Throat 115 mm
Drill depth
Pillar diameter
Height 650 mm
Weight
LPA sound pressure level in idle mode
61,5 dB(A)
LPA sound pressure level in operating mode
74,5 dB(A)
Technical and visual enhancements may be made
without prior notice. All dimensions, notes and
specifications contained in these operating
instructions are therefore subject to change.
Hand/arm vibration is typically less than 2.5 m/s
Noise and vibration were determined in accordance
with EN 61029-1 requirements.
Seite 13
GB
350 W
5
B 16
13 mm
50 mm
46 mm
18 kg
500 W
9
B 16
16 mm
50 mm
46 mm
21,5 kg
2 .
13