Electrolux GA60GLVC Benutzerinformation Seite 30

30 www.electrolux.com
Problem and alarm code
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
The remaining time in the
display increases and
skips nearly to the end of
the programme duration.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling or knocking
sounds from the inside of
the appliance.
The appliance trips the cir‐
cuit-beaker.
The appliance is switched
on but does not operate.
The display shows PF.
The appliance switches off
during operation.
The display shows upd. All
buttons are inactive except
for the on/off button.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
Possible cause and solution
• Refer to the consumption values table in the chapter
"Programme selection".
• This is not a defect. The appliance is working cor‐
rectly.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.
• The AirDry function is activated. You can deactivate
the function. Refer to "Basic settings".
• The tableware is not properly arranged in the bas‐
kets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneous‐
ly all the appliances in use. Check the socket amper‐
age and the capacity of the meter or turn off one of
the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
• Power supply is out of the operating range. The
wash cycle is temporarily interrupted and resumes
automatically once the power is restored.
• Complete power outage. The wash cycle is tempora‐
rily interrupted and resumes automatically once the
power is restored.
• The appliance downloads and installs the firmware
update automatically when it is available. The display
shows upd for the duration of the updating process.
Wait for the process to be complete. If you interrupt
the update process by deactivating the appliance, it
resumes when you activate the appliance.
The firmware update does not change the appliance
performance declaration values.
For alarm codes not described in the
table, contact an Authorised Service
Centre.