General; Application; Technical Data - Senco SHLS90-S Betriebsanleitung

GENERAL

1 General
Please read these operating instructions carefully and thoroughly before using the high load tool for the first time. In
particular, observe the security advice in Chapter 2. These operating instructions must always be readily accessible to
every user.
GB

1.1 Application

The High load SHLS90-S is a stapling head with automatic clip magazine. It is used for permanent installation in
equipment or production lines, e.g. in prefabricated houses (intended Use).
The system is not an independent part and has to be connected with other parts to complete the whole as a machine. The
safety of all hazards must exclude the result from the management and operation of the system.
The system clock cannot be used for vertical movements. Lowering the positioning is possible. The stitching head (5) must
not be removed and used as a portable driving tool.
For security reasons please use only staples stated in "Technical Data".

1.2 Technical data

Description
Order number
Recommened fasteners
Magazine capacity
Size
Weight
Severe Head
Control
Air pressure hose
Connection Trigger Pulse
Required Trigger Pulse
Max. Air pressure
Operating pressure
Issue cycle
Air pressure useage
4 4
SHLS90-S SHLS90-S PP
EM03000 EM05000
Senco Staples Type
S29 S28
2000 Staples
475 x 140 x 623mm
10...11 kg (without fasteners)
Drive SHLS90-S
Pneumatic flow control
12 mm hose connection via hose coupling (subpackage)
5 pin connector (see Section 11.2)
24 VDC/1,5 W (min.0,05 s)
8,3 bar
6 bar
Max. 10 staples
ca. 2.000 l/min at 6 bar
EM03500 EM03600
S23 S19
475 x 200 x 623mm
13 kg