Setting Mode; How To Navigate In Setting Mode - AEG FSK93847P Benutzerinformation

Settings
Display on floor
Brightness
Language
Reset settings
PNC number
Counter (cycle coun‐
ter)
1) For more details, refer to the information provided in this chapter.

7.1 Setting mode

How to navigate in setting
mode
You can navigate in setting mode using
MY TIME selection bar.
A B
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
Values
ON (default)
OFF
0 - 9
List of languages
(default: English)
YES
NO
Number
Number
C
Description
Activate or deactivate TimeBeam.
Adjust the brightness of the display.
Set the preferred language.
Reset the appliance to the factory settings.
The setting does not reset the cycle counter.
Check the PNC number of your appliance.
Check the number of completed dishwashing
cycles. The counter restarts after reaching
65535.
To enter setting mode, press and hold
simultaneously
about 3 seconds.
• The lights related to the
Previous, OK and Next are on.
• The display shows the first
available setting and its current
value.
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
desired setting.
The display shows the setting name and
its current value.
2. Press OK to enter the setting.
The display shows available values.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
ENGLISH 13
1)
1)
and for
for about 3