Troubleshooting; Specifications - ecofort ecodry Pro 35C Bedienungsanleitung

Troubleshooting

Fault
Water drips out when moving
unit
Unit does not operate
Water on the floor
Unit collects too little water

Specifications

Model
Water Removal Capacity
Voltage/Frequency
Rated Power
Rated Current
Air Flow
Noise
Operation Temperature
Refrigerant
Net Weight
Dimensions (W × H × D)
Power Cord
Drain hose
Cause
Unit was unplugged before
purging was completed
No power to unit
Unit not switched on
The set humidity level has
been reached
The drain hose is loose
Room temperature is too low
The doors and windows are
open
The unit has not been used
long enough
The air filter and/or coils are
dirty
ecodry Pro 35C
35L/day (30 °C RH 80%)
20L/day (27 °C RH 60%)
220-240 V ~ 50 Hz
475 W
2.1 A
330 m³/h
50 dB(A)
1 – 38 °C
R290 / 0.135 kg
22.0 kg
310 × 370 × 500 mm
5 meters
5 meters
65
Solution
Purge unit before moving
Plug in unit.
Check power at outlet and
base of unit
Switch on the unit
Choose CO if you still want to
dehumidify after the set value
was reached
Tighten the connection of the
drain hose
Increase room temperature
Close all doors and windows
Allow the unit to run more
time
Check the filters and coils and
clean
ecodry Pro 55C
55L/day (30 °C RH 80%)
35L/day (27 °C RH 60%)
220-240 V ~ 50 Hz
580 W
2.6 A
420 m³/h
55 dB(A)
1 – 38 °C
R290 / 0.2 kg
29.2 kg
345 × 450 × 560 mm
5 meters
5 meters