Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Stand-alone mode
Automatic mode
In automatic mode, 4 programs are available that run at an adjustable speed.
1
Press the MENU button so many times until AUTO is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired program (01-04). Confirm with the ENTER
button.
2
Press the MENU button so many times until SPEED is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from 01 (slow) to 09
(fast). Confirm with the ENTER button.
White color setting
The mode COLOR offers the possibility of adjusting the intensity of the warm white LED. The device will
constantly emit the adjusted color.
1
Press the MENU so many times until COLOR is indicated in the display. Confirm with the ENTER button.
2
Now the display indicates the letter W for the warm white color and the corresponding intensity value.
Use the buttons UP and DOWN to adjust the desired intensity.
Total brightness
Menu DIMMING allows adjusting the total brightness for all stand-alone operating modes.
1
Press the MENU button so many times until DIMMING is indicated in the display. Confirm with the
ENTER button.
2
Use the buttons UP and DOWN to adjust the desired brightness (01 = dark, 99 = bright). Confirm with the
ENTER button.
Fade in and out
FADING mode enables fade in and out. The speed is adjustable.
1
Press the MENU button so many times until FADING is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Strobe effect
FLASH mode enables strobe effects. The flash frequency is adjustable.
1
Press the MENU button so many times until FLASH is indicated in the display Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to adjust the desired speed (00-99). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX lost mode the program offers different options when no DMX signal is received.
Press the MENU button repeatedly until the display shows the DMX lost menu. Press ENTER to
1
confirm.
2
Select the desired program with the UP and DOWN buttons (see Menu structure). Confirm with ENTER.
Cabled master/slave operation
Several devices may be interconnected (max. 32) via DMX cables. Then all slave units can be synchronized
and controlled with the master unit without the need for a DMX controller. The devices must be set to the
corresponding operating modes.
1
Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated on the display. Confirm with the ENTER button.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Set the master unit to a stand-alone mode. The interconnected devices will now operate in
synchronously.
27/32
00138977, Version 1.0
Werbung
Inhaltsverzeichnis
