Carromco 07050 Aufbauanleitung Seite 8

07050
W a r n i n g !
using the fastening straps on the board. Do not mount it to other objects, it is not intended for any other type of use.
The seat is not intended as a flotation device nor as a lifesaving device, never use it for these purposes.
Only use air to inflate the seat. Do not use a compressor or your mouth to inflate the seat.
No t e !
board being swept away and lost.
1. Fasten the SUP leash to the cord on the D ring and tighten it (see Fig. M/N).
2. Open the hook-and-loop fastener on the other end of the SUP leash and close it around your ankle.
6 . 5 I NF LATI NG AND M OUNTI NG
W AR NI NG ! R i s k o f d r o w n i n g !
Use the seat in combination with the boar only and always attach it to the board properly
You can inflate the seat using a commercially available air pump or
bellows with an 18 mm adapter (not included).
1. Remove the valve from the back part of the seat.
2. Open the valve.
3. Inflate the seat. The maximum pressure is reached when you can still
easily press the air chamber above the valve together using your fingers.
4. Close the valve and press it down.
5. Hook the ends of the front fastening straps into the front D rings (see
Fig. L).
6 . 6 ATTACHI NG THE SUP LE ASH
NOTE ! R i s k o f p r o d u c t d a m a g e !
Always use the SUP leash to secure the board. Failure to use the leash may result in the
THE SE AT
-8-
E N G L I SH