List Of Parts; Instruction Manual - Carromco 07050 Aufbauanleitung

07050
Inattention may result the SUP set causing injury to others. Always be mindful of other persons, ships, and boats
while on the water. Always keep a safe distance.
No t e !
board and the seat. If the pressure in the board exceeds 1.04 bar (15 psi), then open the valves and let out some
air. Excessive pressure may cause the material to tear.
• Do not expose the board to sunlight for prolonged periods, as this may increase pressure in the board.
• Only use the SUP set at a safe distance to rocky coasts and do not use it in shallow waters. Shield the product
from pointy objects, fire, and hot surfaces. Otherwise there is a risk of damage to the product.
• Do not transport the SUP set in a vehicle while inflated; deflate the product before transporting it in a vehicle.
• Always secure the board with the SUP leash. Failure to do so poses a risk of the board being swept away and lost.
5. LI ST OF P AR TS
1x Stand Up Paddle Board
1x Pump
1x Backpack
1x Paddle
1x Leash
1x Repairkit
1x Inflatable Seat
1x Fin
No t e !
packaging. Opening the packaging carelessly with a sharp or pointy object can result in damage to the SUP set.
Check the delivery contents for completeness and check the SUP set for any signs of damage. If you discover any
signs of damage to the product or the packaging, contact our customer service at https://carromco.com/contact
6 . I NSTR UCTI ON M ANUAL
Read the following instruction manual thoroughly before use to prevent any possible damages.
W a r n i n g !
shows any signs of damage or leaks, cease use of the SUP set immediately. Otherwise there is a risk of drowning.
No t e !
dry and clean at all times and to prevent the valves from becoming soiled e.g. with sand.
• Only open the valves to inflate or deflate.
• Be mindful or your surroundings when inflating the set and do not inflate the board on a rocky surface or near sharp
or pointy objects.
• Inflate the board to a pressure of 1.04 bar (15 psi). Do not use a compressor to inflate the product; instead use the
provided pump and only use air to inflate the board. If the pressure in the board exceeds 1.04 bar (15 psi), then open
the valves and let out some air. Excessive pressure may cause the material to tear.
4 . 5 NOTE ! R I SK OF P R ODUCT DAM AG E !
• Inflate the board to a pressure of 1.04 bar (15 psi). Do not use a compressor to inflate the
product; instead use the provided pump and only use air to inflate the
5. 1 CHE CK I NG THE DE LI V E R Y CONTE NTS
NOTE ! R i s k o f p r o d u c t d a m a g e !
Check the packaging for signs of damage and proceed with caution when opening the
6 . 1 I NF LATI NG THE B OAR D
W AR NI NG ! R i s k o f d r o w n i n g a n d r i s k o f p r o d u c t d a m a g e !
Failure to proper inflate the board can lead to damage and leaks in the board. If the board
NOTE ! R i s k o f p r o d u c t d a m a g e !
• Always ensure that the valves are securely closed, otherwise air might escape, the board
lose pressure, or the valves become soiled. Make sure to keep the area around the valves
-4-
E N G L I SH