Cleaning With The Brush; Cleaning Under Running Water - Silvercrest SRR 3.7 C3 Bedienungsanleitung

Cleaning with the brush

Cutting unit
Clean the 3 shaving heads of the cutting unit
using the brush
1) Take hold of the cutting unit
3
recesses
2) Tap the cutting unit
3) Use the brush
4) Replace the cutting unit
snaps into place and is seated firmly.
Long hair trimmer
■ Clean the long hair trimmer
e
brush .
■ Oil the long hair trimmer
of sewing machine oil.

Cleaning under running water

1) Take hold of the cutting unit
3
recesses
2) Hold the cutting unit
flows through the shaving heads from the inside to the outside.
CAUTION! MATERIAL DAMAGE!
► Hold only the cutting unit
shaver handset can be damaged irreparably if it is held under
running water.
3) Allow the cutting unit
4) Replace the cutting unit
snaps into place and is seated firmly.
SRR 3.7 C3
e
.
and pull it off.
2
on a flat surface or blow off the hair cuttings.
e
to remove any remaining hair cuttings.
2
4
and pull it off.
2
under the running water so that the water
2
2
to dry.
2
2
2
with three fingers in the grip
flush on the appliance. Ensure that it
4
after every use with the supplied
around every 6 months with a drop
2
with three fingers in the grip
under running water! The
flush on the appliance. Ensure that it
after every shave
GB │ IE │
15 ■