Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance - CONGA 2299 ULTRA HOME X-TREME Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36
ENGLISH
Spiral mode
When you select this mode, the robot vacuum cleaner will intensively clean a specific spot at
maximum power. It will start cleaning at a specific spot and will move outwards in a spiral
motion (1 metre). Then, it will return to the starting spot in an inwards spiral motion again.
-
Before using this mode, place it in the spot you wish to clean.
-
When it finishes and returns to the starting point, the robot vacuum cleaner will stop at the
same point where it started cleaning.
-
To activate this mode, press the spiral cleaning button on the app.
Edge mode
When this mode is selected, the robot vacuum cleaner will clean along walls and around
-
furniture (e.g., table or chair legs).
-
Press the edge cleaning button on the app.
Back Home mode
Press the Back Home button on the robot vacuum cleaner or select the option from the app
(house icon) to send the robot vacuum cleaner to the self-emptying base. The robot vacuum
cleaner will stop vacuuming until it reaches the base.
Manual mode
Select the manual cleaning mode on the app to steer your robot vacuum cleaner manually.
Power level function
Select the power level on the app to control the robot vacuum cleaner's suction power during
cleaning. There are 3 power levels: Eco, Normal, and Turbo.
Cleaning scheduling
To make cleaning easier, the robot vacuum cleaner has a function that allows it to be
programmed daily from the app. According to the setting, the robot vacuum cleaner will
automatically start cleaning in the selected days at the desired time.

5. CLEANING AND MAINTENANCE

High-efficiency filter. Fig. 8.
-
The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to avoid these particles from
building up in the filter, causing efficiency loss. It is convenient to carry out this maintenance
once a week.
-
It is recommended to replace the high-efficiency filter with a new one without exceeding
160 cleaning hours.
52
CONGA 2299 ULTRA HOME X-TREME
Recommendation
You can remove dirt from the high-efficiency filter with a small brush or gently shake the filter
on a hard surface to remove the dust. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter. Fig. 8.
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry and soft cloth to wipe off any dust from the fall-detection sensors located on
the robot vacuum cleaner's lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the main brush. Fig. 9.
The main brush rotates at high speed and helps pulling the dirt into the suction mouth. This
brush is in contact with the floor, and therefore with dirt, so it can be worn out over time,
negatively affecting cleaning efficiency. For this reason, it is suggested to replace the main
brush after a maximum of 320 hours or less.
Slightly press the main brush frame's tabs in order to open the main brush storage gap
1.
and to remove it.
2.
Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
of the self-cleaning brush.
Clear and clean the robot vacuum cleaner's suction channel.
3.
4.
Reinstall the main brush and its frame. 
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brushes. Fig. 10.
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out over time,
ENGLISH
53
CONGA 2299 ULTRA HOME X-TREME

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis