Cleaning And Maintenance - CONGA THUNDERBRUSH 650 Bedienungsanleitung

ENGLISH
WARNING: the battery provided is the only one suitable for the vacuum cleaner.
4. OPERATION
1. Place the appropriate accessory on the aluminium hose's end.
2. Press the ECO button located next to the handle for the appliance to operate at low
consume.
3. Press the power button located next to the handle for the appliance to operate at
maximum power and press again to stop operation.
NOTE: the light indicator will turn on during operation.

5. CLEANING AND MAINTENANCE

Dust tank
• Press the dust tank release button to open the dust tank.
• Place the dust tank above the bin and gently shake it in order to empty all the dust.
• Remove the dust tank by turning it anticlockwise and wash it with water if necessary.
• Dry thoroughly the dust tank before inserting it back again in its place.
Filters
• Remove the dust tank (see "Dust tank installation").
• Take out the filter set from inside and separate the microperforated filter from the HEPA
one.
• Clean the dust from each filter and wash them in water if necessary. In case they are
washed with water, make sure to dry them completely before introducing them back in
the dust tank.
• To introduce the filters, align the guide on the edge with the slot on the inside part of the
dust tank and slide it down to its correct position.
• On the top part of the main body, use the tab to open the compartment and remove the
sponge filter and the felt. Tap it gently to remove all dust, clean it with water if necessary
and make sure it is properly dried before inserting it back to its position.
NOTE: Do not wash the felt.
Aspiration base
• Press the aspiration base release button and pull
from the aspiration base to remove it.
16 CONGA THUNDERBRUSH 650 IMMORTAL BATTERY 22.2 V
05116_ThunderBrush_650_MV_YV_011912'4.indd 16 05116_ThunderBrush_650_MV_YV_011912'4.indd 16 4/12/19 11:54 4/12/19 11:54