Electrical Connection (U.k. Only) - DeLonghi HCO420FT Bedienungsanleitung

Eletrischer heizkonvektor

Vorschau ausblenden

Seite von 46

/ 46
Lesezeichen

Verfügbare Sprachen

Voltage

Wattage

Tension

puissance

Spannung

Leistung

Tensione

potenza

Spänning

Effekt

Tension

véase placa de características

Potencia

Voltagem

ver placa de especificações

Potencia

Tav s h

blev p e pinakiv d a me carakthristikav

Iscuv "

A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the

plug should be cut off from the mains lead, and on appropriate plug fitted, as below. WARNING: Very care-

fully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the

house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must

be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when chan-

ging the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug

must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The

colour of the correct replacement fuse cover is that as marked on the base of the plug.

B) If your appliance is not fitted with a plug, please follow the instructins provided below:

The wires in the mains lead are coloured in accordance with the following code:

As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the ter-

minals in your plug, proceed as follows:

The blue wire must be connected to the terminal marked with the letter N or coloured black.

The brown wire must be connected to the terminal marked with the letter L or coloured red.

If you have a 3-pins plug, do not connect any wire to the "earth" terminal.

See rating label

voir plaquette données

siehe Typenschild

vedi targa caratteristiche

zie plaatje