Console Features; Weather Forecast; Barometric Pressure - Bresser WIFI WSC 5IN1 Bedienungsanleitung

11 SENSOR / WI-FI
12 REFRESH
13 CONTRAST
14 RESET
15 Power jack
16 Wall mount hole
17 Battery compartment
4.3

CONSOLE FEATURES

4.3.1 WEATHER FORECAST

The built-in barometer continually monitor atmosphere pressure. Based on the data collected,
it can predict the weather conditions in the forthcoming 12~24 hours within a 30~50km (19~31
miles) radius.
Sunny Partly cloudy
NOTE:
- The accuracy of a general pressure-based weather forecast is about 70% to 75%.
- The weather forecast is reflecting the weather situation for next 12~24 hours, it may not necessarily
reflect the current situation.
- The SNOWY weather forecast is not based on the atmospheric pressure, but based on the temperature
of outdoor. When the temperature is below -3°C (26°F), the SNOWY weather icon will be displayed on the
LCD.

4.3.2 BAROMETRIC PRESSURE

The atmospheric pressure is the pressure at any location of the earth caused by the weight
of the column of air above it. One atmospheric pressure refers to the average pressure
and gradually decreases as altitude increases. Meteorologists use barometers to measure
atmospheric pressure. Because absolute atmospheric pressure decreases with altitude,
meteorologist correct the pressure relative to sea-level conditions. Hence, your ABS pressure
may read 1000 hPa at altitude of 300m, but the REL pressure is 1013 hPa.
To obtain accurate REL pressure for your area, consult your local official observatory or check
weather website on internet for real time barometer conditions, and then adjust the relative
pressure in Calibration (section 5.6) of configuration app.
1. Rate of change graph for the barometric pressure
2. Pressure drop alert indicator
3. Average hourly pressure of 3, 6, 12, or 24 hours ago
4. Barometric pressure trend
5. Barometric pressure reading
4.3.2.1 VIEWING PRESSURE HISTORY
In normal mode, press [ BARO ] key to view the average hourly pressure of 3, 6, 12 and 24
hours ago.
Press to start sensor synchronization (paring)
Press and hold 6 seconds to enter AP mode, vice versa
Press to update the upload data and time synchronization
Press to adjust the LCD viewing angle to fit table stand or wall mount
situation.
Press to reset the console
Press and hold 6 seconds to factory reset the console
Cloudy Rainy Rainy / Stormy
15
Snowy
1 2 3
4
5