Husqvarna 1-8DPS30 Bedienungsanweisung Seite 14

The separator tray keeps contamination away from the
abrasive and the blastwheel.
To fill the product with abrasive
WARNING:
protective equipment during operation. Refer
Personal protective equipment on page 6 .
to
1. Close the abrasive valve. Refer to
abrasive valve on page 12 .
2. Unlock the cover and lift the handle to open the
separator.
3. Open the separator tray and remove all
contaminations when you fill abrasive or when it is
necessary.
4. Fill the separator with abrasive up to the separator
tray. Fill abrasive when it is necessary.
14
Always use personal
To operate the
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Attach the dust extractor hose safely to the
connection for dust extractor. Connect the attached
parts with the supplied tool and industrial tape.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To do a check of the direction of
rotation of the motor
1. Start the product. Refer to
page 15 .
2. After some seconds, stop the product. Refer to
stop the product on page 18 .
Do not use the dust
To start the product on
To
2087 - 002 - 05.04.2023