Husqvarna 1-8DPS30 Bedienungsanweisung Seite 12

5. Put the quick-release pin in the storage position.
6. Close the drive chain cover.
Abrasive valve
The magnetic abrasive valve controls the flow of the
abrasive shot to the blastwheel. The adjustment of
the abrasive valve is shown on the ammeter. Refer to
Ammeter on page 8 .
The abrasive valve is adjusted with the abrasive control
To operate the abrasive valve on page
cable. Refer to
12 .
To operate the abrasive valve
CAUTION:
valve when the blast motor is in operation.
1. Pull the abrasive control cable to open the abrasive
valve and adjust the flow of abrasive shots.
12
Only open the abrasive
2. Push the abrasive control cable to close the abrasive
valve and adjust the flow of the abrasive shots.
Abrasive seal
The abrasive seal makes sure that the abrasive stays
in the product during operation. The abrasive seal has
magnetic seals (A) on the sides and in front of the
blast housing. Brush lists (B) are attached around the
magnetic seals.
The skid seal (C) moves on the surface.
A
B
C
2087 - 002 - 05.04.2023