Husqvarna 1-8DPS30 Bedienungsanweisung Seite 13

To adjust the height of the magnetic
seals
1. Loosen the 2 adjustment screws at the rear wheels.
2. Loosen the adjustment screw at the front wheel.
3. Adjust the height until the magnetic seals are 8–10
mm from the surface.
4. Tighten the screws.
To adjust the height of the brush list
seals
The brush list seals wear when you operate the product.
It is necessary adjust the height of the brush list seals at
regular intervals.
2087 - 002 - 05.04.2023
1. Loosen the 2 screws that holds the brush list.
2. Adjust the height of the brush list until the brush list
is 1 mm above the surface.
3. Tighten the 2 screws.
Abrasive
Speak to your Husqvarna dealer for the selection of
correct abrasive for your surface operation. Refer to
Approved abrasive on page 27 .
Abrasive separator
The abrasive separator makes the abrasive free
from contamination. The abrasive separator holds the
abrasive and supplies the blastwheel with abrasive.
13