Clean Air Optima CA-106 Smart Gebrauchsanweisung Seite 11

Wind speed table natural wind:
3. Sleep mode: In sleep mode, the display will turn off and the fan is running in the low-
est speed level.
Press the MODE button to switch back again in the settings before.
SPEED Button
By pressing the Speed button, you can change the speed level. The 3 fan speeds offer
individual air flow (1-2-3 means the wind speed increases).
OSC oscillating function
The oscillation function ensures good air distribution in the room. Oscillating
distributes the air evenly. There are two positions, fixed or moving.
PURIFIER button
1. Press the PURIFIER button to start or stop the air purifying function. Meanwhile, the
air outlet automatically shifts to the HEPA air filter purification and the air purification
function starts. When the function is turned off, the air outlet automatically moves
back to the front of the air cooler and the cooling function starts.
2. The PM sensor takes 60 seconds to measure the air quality. During this process,
the display alternately shows the colors red, yellow and green. After 60 seconds, the
corresponding color will be shown on the display based on the detected air quality
level.
Green - Good: <35ug/m³
3. After starting the air purification function, you can manually select the air purification
intensity by adjusting the wind speed. The oscillating function and mode button do
not work during the air purifying function.
Orange - Average: 35-100ug/m³ Red - Bad: 100 ug/m³ or more
11