Installation; Assembly - SOMFY Tilt Only 50 RTS Central Pack Anleitung

Tilt Only 50 RTS Central Pack

2. INSTALLATION

Attention
• These instructions are mandatory for the drive and home
automation professional installing the drive.
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.

2.1. ASSEMBLY

2.1.1. Preparing the drive
1) Cut the head rail shaft to the desired length.
2) Place the head rail and shaft adaptors on the
drive.
2.1.2. Fitting the drive inside the head rail
1) Insert the drive into the head rail.
Attention
Make sure not to cut the power supply
cables on the edges of the head rail
when inserting the drive.
2) Slide the shafts to the end stops of the drive's
shaft adaptors.
͉
For optimum radio reception, the antenna must
be kept straight and outside the head rail.
͉
It can be installed in a central or lateral position.
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1 1
2 2
1 1
2 2
EN
19