Adding And Deleting An Rts Control Point - SOMFY Tilt Only 50 RTS Central Pack Anleitung

EN
2.4.3. Modifying the direction of rotation of the drive
1) Move the motorised product to a position other
than the end limits.
2) Press and hold the Up and Down buttons
simultaneously until the motorised product
moves up and down and the orange LED
flashes slowly.
3) To reverse the direction of rotation, press the
my button until the motorised product moves
up and down and the green LED flashes five
times.
4) Press the Up button to check the new direction
of rotation.
The motor rotation direction is reversed.
2.4.4. Modifying the direction of rotation of the drive
wheel
1) Move the motorised product to a position other
than the end limits.
2) Press and hold the Up and Down buttons
simultaneously until the motorised product
moves up and down and the orange LED
flashes slowly.
3) To reverse the direction of rotation of the
jogwheel, press the Up, my and Down buttons simultaneously until the
motorised product moves up and down and the green LED flashes five times.

2.4.5. Adding and deleting an RTS control point

Find an RTS control point (A) programmed into the
drive.
Press and hold the Prog button on the programmed
RTS control point (A) or the Prog button on the drive
until the motorised product moves up and down. The
green LED flashes five times then the orange LED
flashes. The drive is in programming mode.
24 Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Tilt Only 50 RTS Central Pack
1 1
2 2 3 3
4 4
1 1
2 2
3 3
PROG.
A
PROG. PROG.
A B
PROG.
A
PROG. PROG. PROG. PROG. PROG. PROG. PROG. PROG. PROG.
A A A A A B B B
PROG.
B
PROG.
B
PROG. PROG. PROG
B B A B
PROG. PROG.
A B