Inner Lining; Ventilation - SCHUBERTH C5 CARBON Gebrauchsanweisung

Tip:
Stubborn soiling on the outside of the visor (e.g. dried-on insect residue) is
easy to remove if you cover the closed visor with a damp cloth for a few
minutes to soften the deposits. Repeat this procedure if required.
Note:
Always avoid temperatures above 40 °C and high humidity when choosing
a place to store the visor, as these conditions can cause damage to the
visor.

4. INNER LINING

The inner lining of the C5 can be removed completely. The neckroll, head and
cheek pads can be washed by hand using a mild soap solution (e.g. with highly
diluted standard mild detergent) at a maximum temperature of 30 °C. Allow the
lining to dry at room temperature and with good ventilation.

5. VENTILATION

VENTILATION COWL
When necessary, the head ventilation system's air inlet cowl can be
removed to clean the ventilation mechanism and ventilation grille.
1. Set the slider of the
ventilation hood to the rear.
2. Slightly lift the ventilation hood at the
front and pull it forward until the ventilation
hood is released from the helmet shell.
EN
89