Installation - Cameo G4 T Bedienungsanleitung

1
RAIL ADAPTER
Rail adapter for mounting on a compatible 3-phase rail.
2
TILTABLE AND SWIVELLING SUPPORT ARM
Support arm with two joints for adjusting the beam direction on the horizontal and vertical plane.
3 DIMMER
Dimmer for adjusting the brightness.

INSTALLATION

HAZARD: Overhead mounting requires extensive experience, including the calcula-
tion of the load limit values of the installation material and regular safety inspection
of all installation materials and spotlights. If you do not have these qualifications, do
not attempt to perform an installation yourself. Refer instead to a qualified profes-
sional. There is a risk that devices that are incorrectly mounted and secured may
come loose and fall down. This can cause serious injury or death.
DANGER: Only use the spotlight for horizontally mounted rails (horizontal ceiling
mounting)! The spotlight is not suitable for inclined rails and wall mounting!
WARNING: Before mounting or dismounting, make sure that no electrical voltage is
applied to the 3-phase rail (switch off fuses)!
ATTENTION: The spotlight is not suitable for use with external dimmers!
Use the knurled wheel A to set to phase 1, 2 or 3 (see window below the knurled wheel; 0 =
off). The adjustment can be made before or after mounting on a rail. To mount on a rail, open the
locking lever B of the rail adapter (lever in open position in the illustration) and then press the
adapter into the rail until it lies flat on the rail edges (Fig. 1). Secure the connection by closing the
locking lever again (Fig. 2).
12