Ambient Temperature - Cameo G4 T Bedienungsanleitung

ATTENTION:
1. Do not install or operate the device near any radiators, heat registers, stoves or other
heat sources. Ensure that the device is always installed in such a way that it is suffi-
ciently cooled and cannot overheat.
2. Do not place ignition sources such as burning candles near the device.
3. Ventilation openings must not be covered and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for transport.
5. Avoid shock or impact to the unit.
6. Observe the IP protection class as well as the ambient conditions such as tempera-
ture and humidity according to the specification.
7. Devices can be constantly further developed. In the event of deviating information on
operating conditions, performance or other device properties between the user manual
and the device labelling, the information on the device always takes priority.
8. The unit is not suitable for tropical climates and for operation above 2000 m above
sea level.
9. Unless explicitly stated, the unit is not suitable for operation in marine conditions .
For conversion or retrofit sets or accessories provided by the manufacturer, it is
essential to observe the instructions included.
CAUTION! IMPORTANT INFORMATION REGARDING LIGHTING PRODUCTS!
1. Never look directly into the beam of light, not even for a short period of time.
2. Never look into the beam of light using optical devices such as a magnifying glass.
3. Stroboscopic effects may cause epileptic seizures in susceptible individuals!
4. Permanently installed lamps are built into these lighting units. These may not
be replaced by the user. The lamps contained in this lighting unit may only be
replaced by the manufacturer, its service partner, or a similarly qualified person.

AMBIENT TEMPERATURE

Please observe the maximum ambient temperature in operation specified in the tech-
nical data. A special protection circuit in the headlamp ensures that the brightness
is reduced if the ambient temperature is too high to protect the unit components. If
you notice a significant loss of brightness in the headlamp, please check the ambient
temperature in the direct vicinity of the headlamp and, if necessary, ensure that the
temperature is brought to or below the maximum permitted value.
9