Tesla RoboStar iQ100 Bedienungsanleitung Seite 18


Dust can be removed from the dust bin using clean water.
Press the release button to remove the dust bin and tip the dirt into your household bin.
HEPA FILTER
In order to preserve the filtration parameters of the HEPA filter, we recommend that you clean it without
using water. If you decide to wash the HEPA filter with water, this will reduce its filtration ability. Clean
the HEPA filter regularly according to how dirty it is, at least once a week, using the dust brush provided
or clean it using a conventional vacuum cleaner.

Do not clean the HEPA filter with your fingers or brush, only with clean running water (do not use
cleaning agents).

Allow the HEPA filter to dry thoroughly. Never install a wet HEPA filter in the robot vacuum cleaner!

Vacuuming with a dirty HEPA filter or with no HEPA filter inserted may damage the robot vacuum
cleaner.

We recommend that you replace the HEPA filter after 6 months of use.
SIDE CLEANING BRUSHES - clean once a week
Check both side cleaning brushes according to intensity of soiling, at least once a week, together with
the air intake opening and remove any tangled hair and other debris from them.
SENSORS, CHARGING CONTACTS AND CHARGING STATION - clean once a week
Clean the sensors (see figure) on the bottom of the robot vacuum cleaner once a week with a soft dry
cloth. Check that the front bumper below which the impact sensor is located is not blocked.
Clean the contacts on the bottom (see figure) of the robot vacuum cleaner and the contacts on the
charging station with a soft cloth.
FRONT CASTOR WHEEL - clean once a week
Keep free of hair and dust. Remove the central guide wheel from the vacuum cleaner by pulling it out
from the body of the vacuum cleaner, also clean the wheel axle and then reinstall it in the robot vacuum
cleaner.