Tesla RoboStar iQ100 Bedienungsanleitung Seite 16

with water. Only refill the water reservoir after removing the reservoir from the vacuum cleaner.
Some residual water may leak when handling the mopping container. In this case, wipe the spilled
area with a dry cloth immediately.

We recommend that you mop the floor with clean water, detergent can cause frothing and make it
more difficult for water to drip onto the mop or cause streaks on the floor after it has dried.

Carefully insert the water reservoir into the body of the robot vacuum cleaner. Do not pour water
onto the vacuum cleaner or its internal parts, the vacuum cleaner is not waterproof.

For the best results of mopping, we recommend that you use this function in one room and then
move to the next room.
To mop, press the "6" or "11" button on the remote control. Do not allow the vacuum cleaner to remain
needlessly in one place without moving or with water residue in the water reservoir.

Do not mop carpets.

Keep a sufficient amount of water for mopping in the mopping module.

Once cleaning has finished, always pour away the remaining water from the water reservoir, rinse
and dry the mopping cloth.

Do not charge the battery with the water reservoir filled with water to ensure your safety.
CONTROLLING THE ROBOT VACUUM CLEANER USING A SMARTPHONE
1.
Switch on the robot vacuum cleaner using the "2" button.
2.
Install the application for controlling the robot vacuum cleaner in your smartphone and follow the
guide for connection of your smartphone and the robot vacuum cleaner.
3.
Android: search for "Tuya Smart" in Google Play
Apple: search for "Tuya Smart" in Apple Store
4.
Connect your mobile phone to your 2.4 GHz WiFi network and switch on GPS.
5.
Create an account in the application.
6. +
Click on the " " button in the application.
7.
Select "Small home appliances" in the application on the left, select "Vacuum cleaner (WiFi)" on
the right
8.
Select your WiFi network (your WiFi router) and enter the password for connection to this WiFi
network.
9.
Change "EZ mode" to "AP Mode" in the application in the top right.
10. Hold down the "3" button on the vacuum cleaner until it starts to beep repeatedly, the On button
indicator will start to flash. Confirm this step on your phone screen and select "Next".
11. Press the "CONNECT" button to confirm access to WiFi network settings for the mobile phone and
connect it to the WiFi Hotspot created by the vacuum cleaner called SmartLife. After connection,
go back to the "Tuya Smart" application and wait for connection of the vacuum cleaner. If
automatic connection does not begin, confirm the option with the "RETRY" button and again
confirm the WiFi network Smartlife.
12. Once the vacuum cleaner has been paired, confirmation of successful connection will be
displayed in the mobile application. Confirm this using the "CLOSE" button.