EINHELL FIXETTO 18/38 S Originalbetriebsanleitung Seite 18

To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.4 Battery capacity indicator (Fig. 7)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (e) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too high. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
6.1 Operation (Fig. 2)
Each time before starting to work, use the fi lling
level indicator (5) to check if the magazine
contains any staples and make sure that the
magazine cover (3) is properly closed.
Important!
Determine the required and optimum depth of
penetration of the staples by fi rst using a test
workpiece which is similar in structure and
Anl_FIXETTO_18_38_S_SPK13.indb 18 Anl_FIXETTO_18_38_S_SPK13.indb 18
GB
material thickness to the workpieces you want to
join.
6.2 Triggering shots (Fig. 1)
The built-in trigger catches prevent the cordless
stapler from being triggered accidentally. As the
result a shot can be triggered only when you
press the stapler head (6) of the cordless stapler
against the material and actuate the trigger (1).
Single shot
Set the selector switch for single shot / repeat
shot (11) to single shot.
Place the stapler head (6) of the cordless stapler
against the workpiece ready for stapling. Pull the
trigger (1) once and let it go again after each shot.
Repeat shot
Set the selector switch for single shot / repeat
shot (11) to repeat shot.
Pull and hold the trigger (1). Each time you now
place the trigger catch (6) against the workpiece
the cordless stapler will shoot repeatedly until you
release the trigger (1).
If the staple goes in too far or if it does not
go in far enough you can adjust the depth of
penetration with the depth adjuster (Fig. 1/Item 9)
(see section 6.4).
Important!
To prevent the cordless stapler from overheating,
you must take a break of 20 minutes after approx.
500 shots in repeat mode.
6.3 Jammed staples (Fig. 10-11)
If a staple becomes jammed in the tool, proceed
as follows:
•
Remove the battery from the tool.
•
Open the magazine cover (3).
•
Undo the four screws for the cover plate (7)
as shown in Fig. 10.
•
Remove the cover plate (7).
•
Remove the jammed staples.
•
Refit the cover plate. Take care to fit in the
right direction and order.
•
Screw the cover plate (7) securely back in
place.
- 18 -
19.12.2022 10:06:34 19.12.2022 10:06:34