Checking The Tyres; Batteries; Charging Batteries - B+B Ejoy MD Bedienungsanleitung

Ejoy MD
| Electric wheelchair
Ejoy MD XL
| Electric wheelchair

7.2.3. Checking the tyres

The tyres will wear over time.
• Therefore check they are intact before setting off each time.
• Check the tread depth of the tyres. It should be at least one mil-
limetre. The air pressure must match the values specified in the
technical data (see Chapter 6).
Contact your dealer if the tyres are defective or worn.

7.3. Batteries

Your wheelchair is fitted with maintenance-free batteries, so you do not
need to check the liquid level.
If your wheelchair is not used for a longer period of time, you must
connect the charger every 4 weeks, otherwise the batteries could be
damaged by deep discharge.
Before setting off each time, check the charge status of your battery by
looking at the battery status display on your control unit. If the battery
status display is only showing red LED's, you should not travel longer
journeys and connect the battery charger to the wheelchair immedi-
ately. We recommend that you connect the charger to the wheelchair
after every trip.
Only use an approved charger to charge the batteries
(see technical data). Please also follow the operating
instructions for the charger!
112
Electric wheelchair |
Electric wheelchair |

7.3.1. Charging batteries

Only use approved chargers to charge the batteries (type in accordance
with the technical data or as delivered by the Bischoff & Bischoff dealer
Fig. 53).
Please also follow the operating instructions for the charger!
Do not charge frozen batteries.
The batteries must be charged when the temperature is between 0°
and 40°C.
When using the scooter for the very first time, we recommend driving
until just 3 bars are visible in the display
(see Chapter 6.1) and recharge the batteries at that point.
In the event that this charge level is displayed, you should recharge the
batteries as soon as possible in order to avoid deep discharge.
Recharging requires approx. 12 - 16 hours.
When using the product after that, you can recharge the batteries at
any battery charge level.
You can interrupt the charging procedure even if the batteries are not
fully charged, if you need to continue driving, for example.
But where possible, always charge to 100% so that you have the great-
est range.
Charging batteries:
• First switch the scooter off.
• Before you start using the charger, check that the power supply is
230 V.
• Connect the charger to the power socket (230 V) and then with the
charging socket of the scooter (Fig. 54).
• The charging socket is located on the side below the ignition switch
(Fig. 55).
• Once the charging procedure is complete, unplug the mains plug
and disconnect the scooter from the charger.
• When not in use, the battery should be charged once a month in
order to avoid deep discharge.
• Deep discharge shortens the service life of the battery significantly,
or the battery may also be damaged by the deep discharge.
Bischoff & Bischoff GmbH - 2023-04-06 - Revision: 2
Ejoy MD
Ejoy MD XL
53.
54.
55.
113