Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ejoy MD
| Electric wheelchair
Ejoy MD XL
| Electric wheelchair
Toggle switch for operating mode
Use the toggle switch (A) (Fig. 43) select the operating mode, whether
the wheelchair will be controlled by the attendant control unit or by the
user. The selected operating mode will be shown through the LEDs (B).
The red LED lights up when the wheelchair is being controlled by the
user. The green LED lights up when the wheelchair can be controlled
by the attendant.
Adjustment function button
All R-NET attendant control units are fitted with an adjustment func-
tion button as standard. If the R-NET control unit is not programmed
with any adjustment options, this button has no function.
However if the R-NET control unit is programmed with 1 or up to 4
adjustment options, the functions for this button are described in the
relevant section below.
Wheelchairs with up to 4 adjustment options
Pressing the adjustment function button (C) once will activate the set-
up mode for the electronic adjustment options.
By deflecting the joystick forwards or backwards, you can control the
relevant adjustment direction for the individual channels. Select be-
tween the adjustment options by deflecting the joystick to the left or
right. When you change the selected adjustment option, this is shown
on the control panel of the user's control unit.
To return to drive mode, either press the adjustment function button
(C) or the speed level button (E).
Speed levels display
Indicates the speed level adjustment for the wheelchair, if the atten-
dant control unit is activated. There are five settings - setting 1 is the
lowest speed and setting 5 is the highest speed. The speed level is
adjusting using the (E) button.
98
Electric wheelchair |
Electric wheelchair |
Button for speed level adjustment
Use this button (E) to adjust the speed level of the wheelchair, if the at-
tendant control unit is activated. By pressing this button, the maximum
possible speed of the relevant drive speed will be increased by one
level, until you reach level 5. Pressing again will reset the speed back
to level 1. If the control unit is programmed for operation with drive
profiles, only the speed level within the selected profile will be adjusted
using the button for speed level adjustment of the positioning system.
4.8. Adjustments to the Control unit
Changes to the programming of the control unit must not be carried
out and voids the product conformity and road approval. Changes to
the programming have an impact on speed, acceleration and brake
delay. If carried out incorrectly, this can lead to fatal injuries to the user
and/or a third party.
4.9. Getting in and out of the chair
Side transfer
•
Position the wheelchair and the current or future seat surface side
by side, as close as possible to one another.
•
If you are transferring from another wheelchair or indoor frame,
secure these by applying the parking brakes.
•
The wheelchair must be secured so that it cannot roll away uninten-
tionally. To do this, switch the control unit off by pressing the ON/
OFF button (when the control unit is switched off, all displays are
unlit).
•
Remove the armrest/sideguard.
•
Flip the footplates to the side or remove the legrests.
•
Now slide sideways onto the other seat surface.
•
Please make sure that you are sitting as far back in the seat as
possible.
•
Re-fit the armrests and legrests back in their
initial positions.
Bischoff & Bischoff GmbH - 2023-04-06 - Revision: 2
Ejoy MD
Ejoy MD XL
99
Werbung
Inhaltsverzeichnis
