Mounting Distances; Fastening - ATH-Heinl Single Lift 12PL Bedienungsanleitung

2.5

Mounting distances

L1
B1 min. 1000 mm
min. 1000 mm
L1
min. 4500 mm
L2
min. 3500 mm
H
2.6

Fastening

Warning
General as well as local regulations must be observed when fixing the device.
Therefore, these steps should only be carried out by a trained specialist.
The machine is to be set up and fastened on sufficiently solid ground, if necessary, according to the minimum
requirements of the specifications in the foundation plan.
The machine must be fastened at the intended points with suitable fastening material, if specified.
When selecting the installation site, the guidelines and instructions of the accident prevention regulations and
the workplace regulations must be observed in addition to the ground conditions.
When installing on floor ceilings, their sufficient load-bearing capacity must be checked. In general, it is
recommended that a building expert be consulted for an assessment when installing the device on floor ceilings.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
68
Release date: 02.05.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
L2