EuroLite LED THA-450F Theater Spot Bedienungsanleitung Seite 34

Product IDs
Each device has a unique RDM code before it leaves the factory to distinguish it from other devices.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when
the device is installed in a remote area.
RDM is integrated in DMX without influencing the connections. The RDM-data is transmitted via the standard
XLR-poles 1 and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be
operated in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not
influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
Error. Logs
This function can be used to read out and reset error messages
Software version
With this function, you can display the software version of the device.
Test
Reset. Motor
With this function you can reset the zoom of the device via the Control Board.
Panel.Ctrl.
With this function, you can adjust each channel manually without controller.
Calibrate
With this function, you can calibrate the zoom, as well as the white setting. The password for this function is
„050".
34/44 00144838, Version 1.0