Werbung
Before first Use
Unpack the device and accessories and check all parts for transport damage.
Do not use the device if parts or the base itself are damaged.
Clean all parts of the device before using it for the first time. To clean the
device, use a slightly damp cloth, if necessary with a little washing-up liquid.
Do not clean the device in the dishwasher and do not immerse the electrical
part of the device in water or other liquids.
When using the device for the first time, let it run empty for 30 minutes. Then
rinse the support grids by hand and dry them thoroughly. This process is only
necessary the first time.
Support Grids
The device has 5 support grids and a herb tray. Depending on the amount of food
to be dried, the device can be operated with 1 to 5 grids (maximum 7 grids).
Additional gratings are available from Westfalia (replacement grating set of 2
Article 98 55 01).
To ensure optimal heat distribution, please always use the attachment, which is
closed in the middle, in the uppermost position.
Herb Tray
Place the herb tray in one of the shelf grids. Put the herbs on top and dry for up
to 5 hours.
Assembly and Set-Up
1. Place the device on an even and horizontal surface.
2. First place the stackable support grids on top of each other and connect the
device to a socket. "00" flashes in the display.
3. Press the
button. The display shows 01 (1 hour). Press the button
repeatedly until the desired number of hours is reached. The time can be
selected from 1 to 36 hours.
4. Press and hold the
the button repeatedly until the desired temperature is reached. The
temperature can be selected in increments of 5°C between 40 and 70°C.
5. Pressing the
button starts the device. The display shows the selected
temperature and the remaining time alternately.
6. After the time has elapsed, the device switches off.
7. If you want to stop the program prematurely, press the
8. After the drying process, pull out the mains plug!
OPERATION
button for 3 seconds. 55°C appears in the display. Press
11
button once.
Werbung
