Settings - Drivetest Fm300 Handbuch

Drive Test GmbH München

3.10.2 Settings

An initial setting is required before start of operation. This procedure has to be performed for
each sensor separately:

Connect sensor to display unit SEB2.2

Connect display unit SEB2.2 to PC

Start PinchPilot

In the menu go to "Sensor/ Configuration/ Extended"

Activate "Measurement output via Analog Interfaces"

Set maximum force: 250N, 500N, 1000N, 2000N

Push "Write" button
Repeat procedure for each sensor to be used.
Version 7.1
Handbuch / Manual FM300 Seite 73 von 100
Archiv: FM300_DE_EN_V7.1