Cosatto Woosh Trail Bedienungsanleitung Seite 7

Cosatto footmuff 17-
(if specifed)
Backrest 18-
19-
Calf support 20-
21-
Basket 22 & 23-
Hood 24-
25-
26-
27-
28-
29-
30-
31-
32-
33-
Seat cover 34-
35-
Pushchair 36-
Bumper bar 37-
38-
39-
Fitting:
Open the harness (refer to step 10) and remove the chest pads (a).
Fit the footmuff liner to the rear of the backrest (b).
Refit chest pads then close the harness (See step 11).
Removing is a reversal of this procedure.
Lowering:
Raising:
Lowering:
Raising:
Removing:
Refitting is a reversal of this procedure.
Adjusting:
Using the hood extension:
Using the hood sun visor:
Using the hood pocket:
Using the hood viewing window flap:
Fitting the raincover:
Removing is a reversal of this procedure.
Fitting the mosquito net (Hood not extended):
Removing is a reversal of this procedure.
Fitting the mosquito net (Extended hood):
Removing is a reversal of this procedure.
Using the mosquito net pocket:
Removing:
Refitting is a reversal of this procedure.
Removing:
Remove the harness (refer to step 16) & hood (refer to step 33) respectively.
Release the fabric fastener on the underside of the calf support (a).
Release the strap under the seat (b).
Unfasten the fastening tabs on each side of the seat cover (c).
Push down the backrest strap end to expose the opening of the «C» ring (a) and
slide the strap out of the ring (b).
Unfasten the fastening tabs on each side of the backrest (c).
Remove the seat cover off the seat (d).
Refitting is a reversal of this procedure.
Closing:
Always remove the raincover and store it under the seat.
Close the hood fully (refer to step 24) (a).
Activate the free-standing foot (b).
Slide the primary lock lever (c) and rotate the secondary lock handle forward FULLY
(d) to unlock the chassis.
Push the handle downwards (e) until the chassis is locked in place (f ).
Fitting:
Opening:
Removing:
4