Klarstein LUCIFER Bedienungsanleitung Seite 30

EN
30
Problem Potential cause
Electrode is cra-
cked or broken.
The tip of the electrode is
not in the correct position.
Wires and/or electro-
des are contaminated
Burner does not light
with food residue.
when using the igniter
(electrical problem).
Wires are loose or
not connected.
The wires are shorted
between the igniter
and the electrode.
There is no spark.
See the problem "Grease
The burner does
fire or very high flames
not ignite.
above the grill surface".
Fat accumulation.
Sudden drop in
gas pressure. Excess fat in the meat.
Temperature too high.
Strong or gusty wind.
Flames erupt.
Little gas.
Low gas flow.
Fat has accumula-
Recurring fat fire. ted in food debris
around the burner.
Prevention/solution
Replace the electrode.
Clean the wires and elect-
rodes with rubbing alcohol
and cleaning swabs.
Reconnect the wires or
replace the electrode/
wire connection. Check the
insulation of the wires and the
connection, replace the wires
if the insulation is broken.
Reconnect wires or swap
lead/wire assembly.
Replace the igniter wire.
Inspect the wire insulation and
correct connection. Replace
wires if insulation is damaged.
See the problem "Grease
fire or very high flames
above the grill surface".
Clean the burners and
the inside of the grill.
Remove the fat from the
meat before grilling.
Turn the gas regulator down.
Turn the grill opening
into the wind or incre-
ase the flame size.
Fill up the gas bottle.
See problem "Sudden
drop in gas pressure".
Turn the gas regulator to the
"OFF" position and turn off the
gas cylinder shut-off valve.
Leave the cover closed and
let the fire go out. Clean the
grill after it cools down.