Charging Up The Battery; Use - MAXXMEE ITLM-02H Bedienungsanleitung

EN
CHARGING UP THE
BATTERY
Please Note!
■
Do not charge up the device via a
computer because the computer
might be damaged by the high charg-
ing current.
■
Fully unwind the USB cable before
connecting the USB mains adapter.
■
Lay the connecting cable in such
a way that it does not become
squashed or kinked and does not
come into contact with hot surfaces.
 
It is essential that you charge
up the battery fully before you
fi rst use the device in order to
achieve the maximum charging
capacity. If the battery is fully
discharged during use, it must be
fully charged up again before it is
next used.
1. Connect the USB cable (9) to the con-
necting socket (4) of the control unit
for a cuff (2) and to the connecting
socket of the USB mains adapter (8).
2. Only connect the USB mains adapter
to a plug socket that is properly in-
stalled and matches the technical data
of the mains adapter. The plug socket
must also be readily accessible after
connection so that the connection to
the mains can quickly be isolated.
The control lamp (7) in the control unit
lights up red. The battery is charging.
3. When the control lamp lights up
green , the battery is fully charged.
4. First disconnect the mains adapter
from the power supply and then the
USB cable from the mains adapter
and the cuff.
14

USE

Please Note!
■
A tingling sensation / itching during
or after the massage is normal due to
the circulation-boosting effect.
■
Switch off the device immediately if
you experience pain or feel unwell
during use.
■
To prevent overheating, do not use
the device under a blanket or similar
cover.
■
Do not use the device for longer than
20 minutes without a break.
 
Start with the slowest level and
gradually increase the level of
intensity.
1. Place the cuffs (2) around your arms,
feet or legs (Picture B) and fasten
them with the hook-and-loop fasten-
ers (1).
Make sure that they are not applied
too tightly so that they do not be-
come too tight during operation.
2. Press (6) on the control units to ac-
tivate the massage. The control lamp
(7) lights up green. Intensity level 1 is
switched on.
The air chambers in the cuffs are slow-
ly infl ated in two cycles and emptied
again after a few seconds.
3. If required, set intensity level 2 by
pressing again. The control lamp
lights up red.
Please Note: When switched off and
on again, the massage starts again at
intensity level 1.
4. If required, also activate the heating
function by pressing
trol lamp in lights up red.
5. After 10 minutes the massage stops
automatically. It can be stopped at
any time by pressing
(5). The con-
.