Meec tools 012893 Bedienungsanleitung Seite 30

EN
NOTE:
Hold the coupling firmly when removing the
quick-coupling to avoid personal injury as a
result of the hose kicking back.
PUMPING
Without adapter
This application enables simple and precise
filling. The pressure gauge is used to check
the tyre pressure. With the integrated blowout
valve it is possible to reduce the tyre pressure if
it is too high.
NOTE:
The pressure gauge is not calibrated. Check
the tyre pressure with a calibrated pressure
gauge after filling.
1. Put the power switch in the "O" position.
2. Press the lock arm on the pump nipple,
fasten the nipple on the valve and release
the lock arm.
3. Plug the compressor plug into a power
point.
4. Set the switch to "I".
5. Press the trigger on the compressed air
gun and hold in for a few seconds. Release
the trigger and read off the air pressure
on the pressure gauge. Continue until the
required pressure is obtained.
6. Set the switch to "O".
7. Press in the lock arm on the pump nipple
and release from the valve.
8. Unplug the compressor plug from the
power point.
Bike tyres
Valve adapter (10) enables easy pumping up of
bike tyres.
1. Connect valve adapter (10) to the pump
nipple.
2. Press the valve adapter against the valve
and pump.
30
Balls
Ball needle (12) can be used for pumping up
different balls.
1. Press the lock arm on the pump nipple,
fasten the ball needle in the pump nipple
and release the lock arm.
2. Press the ball needle in the valve opening
and pump.
NOTE:
Moisten the ball needle before inserting to
avoid damaging the valve.
Inflatable mattresses etc.
Universal adapter (9) and (13) can be used for
pumping up inflatable mattresses other similar
items.
1. Press in the lock arm on the pump nipple,
fasten the adapter in the pump nipple
and release the lock arm.
2. Press the adapter in the valve opening
and pump.
Objects with 8 mm valve
Adapter nozzle (7) is suitable for all valves with
an inner diameter of 8 mm. Examples of these
are inflatable mattresses, pools and toy boats.
1. Press in the lock arm on the pump nipple,
fasten the adapter the adapter nozzle and
release the lock arm.
2. Screw nozzle adapter (11) in adapter
nozzle (7).
3. Press the adapter in the valve opening
and pump.
Boats and pools etc.
Adapter nozzle (6) can be used for large objects
such as rubber boats and pools with screw
valves.
1. Press in the lock arm on the pump nipple,
fasten the adapter nozzle in the pump
nipple and release the lock arm.