Usa, Canada; Australia, New Zealand - BMW 84105A48C11 Bedienungsanleitung

United Kingdom
Hereby, BURY Sp. z o.o. declares that the radio
equipment type SIM Reader for Personal eSIM is
in compliance with UK Directive 2017, No. 1206.
The full text of the UK declaration of conformity is
available at the following internet address:
https://www.bury.com/documents/06-2022_
UK_DoC_0854_044_SIM_Reader_for_
Personal_eSIM.pdf

USA, Canada

Approval and declaration of conformity
This device complies with Part 15 and Part 18
of the FCC Rules and with RSS-210, ICES-001
and RSS-Gen of the Industry Canada Rules.
Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
FCC ID: QZ9-SRPES
IC: 5927A-SRPES
NOTICE:
Changes or modifications made to this
equipment not expressly approved by BURY Sp.
z o.o. may void the FCC authorization to operate
this equipment.
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help

Australia, New Zealand

235