Scheppach 5906146904 Originalbetriebsanleitung Seite 22

Loose clothes, jewellery or long hair can be caught
in moving parts.
Rubber gloves and
recommended when working outdoors.
Tie long hair back in a hair net.
g. If dust extraction and collection devices can be
mounted, make sure that they are connected
and used properly. Use of dust collection can
reduce dust-related hazards.
Do not let familiarity gained from frequent use
h.
of tools allow you to become complacent and
ignore tool safety principles.
A careless action can cause severe injury within a
fraction of a second.
Power tool use and care
a. Do not overload the device.
Use the correct power tool for your application.
The correct power tool will do the job better and
safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
c. Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any
adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce the risk
of starting the power tool accidentally.
d. Store idle power tools out of the reach of
children and
do not allow persons unfamiliar with the power
tool or these instructions to operate the power
tool. Power tools are dangerous in the hands of
untrained users.
Unused power tools should be stored in a dry,
elevated or closed location out of the reach of
children.
e. Maintain power tools and accessories.
Check whether moving parts function properly and
do not get stuck and whether parts are broken or
are damaged and thus adversely affect the electric
tool function. If damaged, have the power tool
repaired before use. Many accidents are caused
by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
22 | GB
anti-slip footwear are
www.scheppach.com
g. Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions and
the work to be performed. Use of the power tool
for operations different from those intended could
result in a hazardous situation.
Keep handles and grasping surfaces dry,
h.
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool
is maintained.
Safety instructions for compressors
m Attention! The following basic safety measures
must be observed when using this compressor for
protection against electric shock, and the risk of injury
and fire.
Read and observe these instructions before using the
device.
Safe work.
1. Take care of your tools
- Keep your compressor clean in order to work
well and safely.
- Follow the maintenance instructions.
- Check the connection cable of the power tool
regularly and have it replaced by a recognised
specialist when damaged.
- Check extension cables regularly and replace
them when damaged.
2. Pull the connector out of the socket
- When the power tool is not in use or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
3. Check the power tool for potential damage
- Protective devices or other parts with minor
damage must be carefully inspected to ensure
that they function correctly and as intended
prior to continued use of the power tool.
- Check whether
function faultlessly
or whether
the moving parts
and do not jam
parts are damaged.