Electrical Connection; Data Table - STIEBEL ELTRON HSBC 3-HE Installationsanleitung

InstallatIon
HsBC 3-HE
5.

Electrical connection

1 2
1 Terminal
2 Earthing tab
f Disconnect the 3 wires from the terminal and the earthing
tab.
f Remove the terminal and earthing tab.
f Connect the 3 wires to the auxiliary heating element as
shown.
A BK / BN
B BU
PE GNYE
Note
The auxiliary heating element standard delivery in-
cludes two identical wiring diagram labels for covering
"HSBC 3-HE (accessory X2.11)" on the wiring diagram:
- On the back of the front casing
- In these instructions (see chapter "Installation /
Specification / Wiring diagram")
f After installation of the auxiliary heating element,
affix the wiring diagram labels in the corresponding
places.
f Observe the wiring diagram for the appliance.
terminal
XD06.1 Heater terminal (accessories HSBC 3-HE)
www.stiebel-eltron.com
f Make the electrical connection for the auxiliary heating
element.
6. Settings
1
5
1 Temperature selector
f Turn the temperature selector anti-clockwise as far as it will
go to set the maximum temperature (65±5 °C).
7. Specification
7.1

Data table

Electrical data
Connected load ~ 230 V
Rated voltage
Phases
Frequency
Application limits
Temperature setting range
Max. permissible pressure
Minimum cylinder diameter
Minimum cylinder volume
Dimensions
Flange external diameter
Immersion depth
Torque
Weights
Weight
3
1
HsBC 3-HE
200025
kW
V 230
1/N/PE
Hz 50
°C 35-65
MPa 1.0
mm 500
l 150
mm 140
mm 480
Nm 45
kg
HsBC 3-HE |
2
2
5