Stroller Assembly - Joie signature finiti Bedienungsanleitung

Stroller Assembly

(Please refer to figures on page 1-17)
Please read all the instructions in this manual before assembling and using this product.
Open Stroller
see images
-
1 4
Separate storage latch from storage mount , and then lift the handle upwards
1
stroller is open completely.
The seat is reversible.
4
! Check that the stroller is completely latched before continuing to use.
Assemble & Detach Front Wheel
see images
-
5 6
Assemble & Detach Rear Wheel
see images
-
7 8
Assemble Canopy
see images
-
9 11
Assemble & Detach Cupholder
see images
-
12 13
The completely assembled stroller is shown as
14
Stroller Operation
Adjust Backrest
see image
15
There are 4 recline angles for the backrest.
To raise or recline the backrest, rotate the recline handle on the back of the seat, pull down on the backrest.
! Please do not press the releasing button - 3 on the middle of the recline handle when adjusting the angle
15
for the recline.
! Make sure the recline is set properly for use.
! The maximum load of storage pocket on the back of backrest is 0.45kg.
Use Buckle
see images
-
16 17
Release Buckle
Press the button, the buckle will release automatically.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
can lock
automatically. - 2 A "click" sound means the buckle is locked completely.
17
! To avoid serious injury from falling or sliding out, always
! Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
! Do not cross the shoulder belts. This will cause pressure on a child's neck.
23
, a click sound means the
2
16
- 1, and align them with the center buckle, the buckle
17
- 3
17
secure your child with harness.
Use Shoulder & Waist Harnesses
see images
-
18 23
! In order to protect your child from falling out, after your child is placed into the seat, check whether the shoul-
der and waist harnesses are at proper height and length.
- 1 Shoulder harness anchor
18
- 2 Slide adjuster
18
For larger child, use shoulder harness anchor and the highest shoulder slots. For smaller child, use shoulder
harness anchor and the lowest shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the side facing forward.
Thread it through the shoulder harness slot from back to front.
child's shoulder height.
22
Use slide adjuster to change the harness length.
Press the button - 2, while pulling the waist harness to proper length.
23
Use Armbar
see images
-
24 26
Adjust Calf Support
see images
-
27 28
The calf support has 2 positions.
To lower calf support, press the adjustment buttons on both sides of the calf support
support downwards. - 2
27
To raise the calf support, push it upwards. A "click" sound means the calf is locked completely.
Use Front Swivel Lock
see image
29
Rotate swivel lock left to orient, Rotate Swivel Lock right to release
Tip
It is recommended to use swivel lock on uneven surfaces.
Use Brake
15
see images
-
30 31
To lock wheels, step the brake lever downwards.
To release wheels, just lift the brake lever upwards.
Tip Always set the parking brake when stroller is not moving.
Use Canopy
see images
-
32 34
The canopy can be opened completely to protect your child from the sun uttermostly, just unzip the zip
then pull the canopy toward front.
Adjust Handle
see image
35
Switch Seat
see images
-
36 39
Use Storage Bag
see images
40
The maximum load of each storage bag on the both side of basket is 0.45kg.
Rethread it through the slot that is closest to
21
- 1
23
- 3
23
- 1, and rotate the calf
27
29
30
31
, and
33
24